Configuration Reference
Description
Feature
For more information, see the
Cisco
Unified Communications Manager
Administration Guide
.
Enables you to report the CTL and ITL information to
the Cisco Unified Communications Manager, using a
Cisco Unified IP Phone.
CTL and ITL Status Display and
Report
For more information, see
Filter Setup, on page 198
.
Enables users to set the alerting call notification priority
on a subset of lines covered by an alert filter. The
custom filter generates either traditional pop-up alerts
or actionable alerts for incoming calls on the selected
lines. For each filter, only the subset of lines under
coverage will generate an alert. If a filter is turned off,
lines under its coverage will not show alert notifications.
You can configure or edit the default phone filter. If
configured, the default phone filter is displayed to the
user as the Daily schedule filter.
Custom Line Filters
For more information, see
Cisco Unified
Communications Manager
Administration Guide
.
Improves the experience for users with multiple lines
by displaying the primary line with the All Calls view
when a call completes.
To have a phone return to the primary line with the All
Calls filter view active, you must enable both the Show
All Calls on Primary Line and the Revert to All Calls
features.
Default Back To All Calls
For more information, see the
“
Common
Phone Profile Configuration
”
chapter in
the
Cisco Unified Communications
Manager Administration Guide
.
When the Enable End User Access to Phone
Background Image Setting check box is enabled, users
can change the background image (or wallpaper) for
the LCD screen on their phone.
When the Enable End User Access to Phone
Background Image Setting check box is disabled, users
cannot change the background image on the phone.
Default Wallpaper Control
For more information, see
Invoked Recording, on page 189
.
Provides end users with the ability to record their
telephone calls via a softkey.
In addition, administrators may continue to record
telephone calls via the CTI User Interface.
Device Invoked Recording
For more information, see
from Release Button Setup, on page 193
.
Allows users to disconnect a call and get the dial tone
by pressing only one button. When the user presses the
Release button while on a call or while dialing off-hook,
the active call ends and dial tone sounds. The New Call
window appears on the selected line on the phone
screen.
Dial Tone From Release Key
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
143
Features, Templates, Services, and User Setup
Telephony features available for Cisco Unified IP Phone
REVIEW DRAFT - CISCO CONFIDENTIAL
