Table 40: EnergyWise Configuration Fields
Description
Field
Selects the schedule of days for which the phone powers off. Select multiple
days by pressing and holding the Control key while clicking on the days for the
schedule.
By default, no days are selected.
When Enable Power Save Plus is checked, you receive a message that warns
about emergency (e911) concerns.
While Power Save Plus Mode (the
“
Mode
”
) is in effect, endpoints
that are configured for the mode are disabled for emergency calling
and from receiving inbound calls. By selecting this mode, you agree
to the following: (i) You take full responsibility for providing
alternate methods for emergency calling and receiving calls while
the mode is in effect; (ii) Cisco has no liability in connection with
your selection of the mode and all liability in connection with
enabling the mode is your responsibility; and (iii) You fully inform
users of the effects of the mode on calls, calling and otherwise.
Caution
To disable Power Save Plus, you must uncheck the Allow EnergyWise
Overrides check box. Leaving the Allow EnergyWise Overrides checked
with no days selected in the Enable Power Save Plus field does not
disable Power Save Plus.
Note
Enable Power Save Plus
Determines when the phone automatically turns on for the days that are in the
Enable Power Save Plus field.
Enter the time in this field in 24-hour format, where 00:00 is midnight.
For example, to automatically power up the phone at 7:00 a.m. (0700), enter
7:00. To power up the phone at 2:00 p.m. (1400), enter 14:00.
The default value is blank, which means 00:00.
The Phone On Time must be at least 20 minutes later than the Phone
Off Time. For example, if the Phone Off Time is 7:00, the Phone On
Time must be no earlier than 7:20.
Note
Phone On Time
The time of day that the phone powers down for the days that are selected in the
Enable Power Save Plus field. If the Phone On Time and the Phone Off Time
fields contain the same value, the phone does not power down.
Enter the time in this field in 24-hour format, where 00:00 is midnight.
For example, to automatically power down the phone at 7:00 a.m. (0700), enter
7:00. To power down the phone at 2:00 p.m. (1400), enter 14:00.
The default value is blank, which means 00:00.
The Phone On Time must be at least 20 minutes later than the Phone
Off Time. For example, if the Phone Off Time is 7:00, the Phone On
Time must be no earlier than 7:20.
Note
Phone Off Time
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
220
Cisco Unified IP Phone Customization
EnergyWise on the Cisco Unified IP Phone Setup
REVIEW DRAFT - CISCO CONFIDENTIAL
