The package includes these items:
•
One phone bracket
•
One wall bracket
•
Four #10-12x1-inch Phillips-head screws with 4 anchors
•
One sheet metal screw
•
Three #4-40x1/4-inch machine screws
•
One 6-inch Ethernet cable
•
One key if the bracket includes the optional lock
Before You Begin
You need these tools to install the bracket:
•
#1 and #2 Phillips-head screwdrivers
•
Level
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack. For more information about phone installation requirements and warnings, see
IP Phone Installation, on page 55
.
Install Bracket for Phone with KEM
To install the phone on the wall, follow these steps:
Be sure to connect to connect the Cisco Unified IP Phone to the Key Expansion Module before installing
the phone bracket.
Note
Procedure
Step 1
Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
a) Use a level to ensure the bracket is level, then use a pencil to mark the screw holes.
b) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall.
c) Screw the anchor clockwise into the wall until it is seated flush.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
319
Cisco Unified IP Phone Wall Mount
Before You Begin
REVIEW DRAFT - CISCO CONFIDENTIAL
