16
Opening the Access Cover
Follow these steps to open the 2.4-GHz radio access cover:
1.
Position the access point so that its bottom cover is facing up.
2.
Use a T-10 tamper-resistant Torx L-wrench to remove the access cover
retaining fastener. See the illustration below.
If your access point was not configured with a 2.4-GHz radio, go to the next
section. If you are replacing an existing 2.4-GHz radio, go to the
“Removing
a 2.4-GHz Radio” section on page 20
.
1
Access cover screw
1
74458