D-4
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Appendix D Channels and Antenna Settings
Maximum Power Levels and Antenna Gains
Changing the Access Point/Bridge Output Power
This section provides instructions for changing the access point/bridge output power to comply with the
maximum power limits imposed by regulatory domains (see
“Maximum Power Levels and Antenna
Gains” section on page D-3
). Follow these instructions to change the output power settings using your
browser:
Note
Administrator privileges may be required in order to change access point/bridge settings.
Note
To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna
must be professionally installed. The network administration or other IT professional responsible for
installing and configuring the unit is a suitable professional installer. Following installation, access to the
unit should be password protected by the network administrator to maintain regulatory compliance.
Step 1
Open your Internet browser.
Step 2
Enter the access point/bridge IP address in the browser address or location line and press
Enter
. An Enter
Network Password screen appears.
Step 3
Enter your username (default
Cisco
) in the User Name field.
Step 4
Enter the access point/bridge password (default
Cisco
) in the Password field and press
Enter
. The
Summary Status page appears.
Step 5
Click
Network Interfaces
and the network interface menu appears.
Step 6
Click
Radio0-802.11G
and the 802.11G Status screen appears.
Step 7
Click the
Settings
tab and the settings screen appears.
Step 8
On the CCK Transmit Power (mW)
setting, select the maximum CCK power allowed for your antenna in
your regulatory region.
Japan (-J)
(10 mW/MHz EIRP maximum)
5.2 (Omni)
10
10
9 (Patch)
10
10
10 (Yagi)
10
10
11 (Omni)
10
10
12 (Omni)
10
10
13 (Integrated patch)
10
10
13.5 (Yagi)
10
10
14 (Sector)
10
10
21 (Dish)
10
10
1.
A minimum of 2 dBi cable loss must be be used for this configuration.
Table D-2
Maximum Power Levels Per Antenna Gain for IEEE 802.11g (continued)
Regulatory Domain
Antenna Gain (dBi)
Maximum Power Level (mW)
CCK
OFDM