C H A P T E R
6-1
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
6
Using the Command-Line Interface
This chapter describes the IOS command-line interface (CLI) that you can use to configure your access
point/bridge. It contains these sections:
•
Connecting to the Console Serial Port, page 6-2
•
Using a Telnet Session to Open the CLI, page 6-3
•
IOS Command Modes, page 6-4
•
Getting Help, page 6-5
•
Abbreviating Commands, page 6-5
•
Using no and default Forms of Commands, page 6-5
•
Understanding CLI Messages, page 6-6
•
Using Command History, page 6-6
•
Using Editing Features, page 6-8
•
Searching and Filtering Output of show and more Commands, page 6-10
•
Assigning an IP Address Using the CLI, page 6-11
•
Finding the Access Point/Bridge IP Address Using the CLI, page 6-11
