14-10
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
OL-4059-01
Chapter 14 Configuring Filters
Configuring Filters Using the Web-Browser Interface
Step 8
Select
Forward All
or
Block All
from the Default Action menu. The filter’s default action must be the
opposite of the action for at least one of the Ethertypes in the filter. For example, if you enter several
Ethertypes and you select
Block
as the action for all of them, you must choose
Forward All
as the filter’s
default action.
Step 9
Click
Apply
. The filter is saved on the bridge, but it is not enabled until you apply it on the Apply Filters
page.
Step 10
Click the
Apply Filters
tab to return to the Apply Filters page.
Figure 14-6
shows the Apply Filters page.
Figure 14-6 Apply Filters Page
Step 11
Select the filter number from one of the Ethertype drop-down menus. You can apply the filter to either
or both the Ethernet and radio ports, and to either or both incoming and outgoing packets.
Step 12
Click
Apply
. The filter is enabled on the selected ports.