D-2
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
OL-4059-01
Appendix D Error and Event Messages
DOT11-3-RADIO_IF_LO: Interface
[interface] Radio cannot lock IF freq
The unit cannot lock the intermediate
frequency.
None.
DOT11-3-RADIO_RF_LO: Interface
[interface] Radio cannot lock RF freq
The unit cannot lock the radio frequency. None.
DOT11-3-RF_LOOPBACK_FAILURE:
Interface [interface] Radio failed to pass
RF loopback test
Radio loopback test failed at startup time. None.
DOT11-3-TX_PWR_OUT_OF_
RANGE: Interface [interface] Radio Tx
power control out of range
The unit has detected that the radio
transmit power cannot be locked within
the operating range.
None.
DOT11-4-MAXERTRIES: Packet to
client [mac] reached max retries,
remove the client
A packet sent to the client has not been
successfully delivered many times, and
the max retries limit has been reached.
The client is deleted from the association
table.
None.
DOT11-6-ASSOC: Interface [interface],
Station [char] [mac] Associated
A station associated to a bridge.
None.
DOT11-6-ADD: Interface [interface],
Station [mac] Associated to Parent
[mac]
A station associated to a bridge.
None.
DOT11-6-DISASSOC: Interface
[interface], Deauthenticating Station
[mac] [char]
A station disassociated from a bridge.
None.
DOT11-6-ROAMED: Station
[mac-address] Roamed to [mac-address]
A station has roamed to a new bridge.
None.
Unzip Messages
SOAP-4-UNZIP_OVERFLOW: Failed
to unzip
Flash:/c1200-k9w7-mx.122-3.6.JA1/ht
ml/level15/ap_xxx.htm.gz, exceeds
maximum uncompressed html size
The HTTP server cannot retrieve a
compressed file in response to an HTTP
GET request because the size of the file is
too large for the buffers used in the
uncompression process.
Make sure file is a valid HTML page. If
so, you'll have to copy an
uncompressed version of the file into
Flash to retrieve it through HTTP.
802.11 Subsystem Messages
DOT11-6-FREQ_INUSE: Radio
frequency [int] is in use
When scanning for an unused frequency,
the unit recognized another radio using
the displayed frequency.
None.
DOT11-6-FREQ_USED: Radio
frequency [int] selected
After scanning for an unused frequency,
the unit selected the displayed frequency.
None.
DOT11-4-VERSION_MISMATCH:
Require radio version [hex].[int], found
version [hex].[int]
When starting the radio, the wrong
firmware version was found. The radio
will be loaded with the required version.
None.
DOT11-2-VERSION_INVALID:
Unable to find required radio version
[hex].[int]
When trying to re-flash the radio
firmware, the bridge recognized that the
radio firmware packaged with the IOS
firmware had the incorrect version.
None.
Table D-1
Error and Event Messages (continued)
Message
Explanation
Recommended Action