C i s c o C o n f i d e n t i a l - D r a f t 1
2-15
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-9977-05
Chapter 2 Mounting Instructions
Mounting the Access Point
Mounting the Access Point on a Vertical or Horizontal Surface
To mount the access point on a vertical or horizontal surface such as a wall or a roof-overhang, use the
supplied mounting plate. For the correct access point mounting orientations, refer to the
“Access Point
Mounting Orientations” section on page 2-12
.
Step 1
The mounting plate is attached to the access point by two carriage bolts. Refer to
Figure 2-6
for the
location of the carriage bolts securing the mounting plate.
Figure 2-6
Access Point Mounting Plate and Carriage Bolts
170061
1
2
2
3
1
Mounting plate
3
Grounding screw hole
2
Carriage bolts
Step 2
Remove the nuts and washers from the carriage bolts and remove the carriage bolts.
Step 3
Remove the mounting plate from the access point.
