4
–
MCS0-MCS15; Short or Long Guard Intervals
–
DFS for UNII-2 and UNII-2 Extended channels, including 0.5us radar pulse detection
3
Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped
with your access point. The translated warnings are also in the
Translated Safety Warnings for Cisco Aironet Access Points
,
which is available on Cisco.com.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:
20A.
Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless
the device has been modified to be especially qualified for such use.
Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9
inches (20 cm) or more from the body of all persons.
Statement 332
Caution
The fasteners you use to mount the access point must be capable of maintaining a minimum pullout force of 20 lbs
(9 kg) and must use a minimum of 2 holes on the mounting bracket.
Caution
This product and all interconnected equipment must be installed indoors within the same building, including the
associated LAN connections as defined by Environment A of the IEEE 802.af/at Standard.
Note
Use only with listed ITE equipment.
Summary of Contents for Aironet 700W Series
Page 2: ...2 OL 31342 01 May 7 2014 ...
