S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-227
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
FSPF Messages
Error Message
FSPF-3-UNLOCK_FAIL: FSPF failure in releasing lock
Explanation
There is a software failure in releasing lock of the shared resource between FSPF
threads.
Recommended Action
Provide output of 'debug fspf all '.
Error Message
FSPF-3-VSAN_TIMER_ERR: Error in processing VSAN timer event [chars],
error description = [chars]
Explanation
FSPF had an internal error in processing timer event , error description is [chars].
Recommended Action
Provide output of 'debug fspf error'.
FSPF-4
Error Message
FSPF-4-FC2_DOWN_INTF: Received FC2 packet on DOWN interface [chars]
Explanation
FSPF received a FC2 packet on inactive interface [chars] .
Recommended Action
This message may be printed for the first FSPF packet when an interface is
brought up. If the message is seen continuously check if FSPF is disabled on one end for the
interface or the VSAN. Otherwise check 'show interface ' output to see if interface is physically up
only on one side. Also check if there is any error message printed for IPC_PROC_ERR.
Error Message
FSPF-4-FC2_DOWN_VSAN: Received FC2 packet on inactive vsan
Explanation
FSPF received a FC2 packet on inactive VSAN.
Recommended Action
If message seen continuously check if FSPF is disabled on the VSAN
Investigate if VSAN is active and valid domain has been assigned on the switch Also check if
IPC_PROC_ERR message is printed in the syslog.
Error Message
FSPF-4-ILLEGAL_FSM_EVENT: Illegal FSM event for state [chars] in
interface [chars]
Explanation
An illegal protocol event has occurred for the FSPF state machine. The old state was
[chars] for the interface [chars].
Recommended Action
It is possible to get this message if some protocol packet gets dropped but the
system should recover and move back to FULL state. Do 'show fspf interface' to check the state of
the interface. If it is stuck in state other than FULL provide output of 'debug fspf event' and 'debug
fspf fc pkt ' for the interfaces involved.
