S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-259
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IKE Messages
IKE-3
Error Message
IKE-3-CRYPTO_INIT_ERROR: IKEv2 crypto init error: [chars]
Explanation
Crypto initialization error.
Recommended Action
No action is required.
Error Message
IKE-3-ENABLE_ERROR: Unable to store enable flag in configuration
(error-id [hex]).
Explanation
Service failed to store the enable flag in configuration. As a result, it will exit.
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message
IKE-3-FIPS_MODE_ERROR: Could not set FIPS mode
Explanation
The FIPS mode could not be set by IKE.
Recommended Action
No action is required.
Error Message
IKE-3-IKE_PROGRAM_EXIT: [chars]
Explanation
IKE process did an abnormal exit.
Recommended Action
No action is required.
Error Message
IKE-3-MAX_HALF_CONN_LIMIT_REACHED: IKEv1 : Exceeded the limit for
number of half open Phase 1 connections
Explanation
The number of half open connections has exceeded the maximum limit.
Recommended Action
No action is required.
Error Message
IKE-3-PHASE1_NEGOTIATION_FAILED: IKEv1: Phase 1 negotiation failed
for peer [chars]
Explanation
IKE policy negotiation failed for peer [chars].
Recommended Action
No action is required.
Error Message
IKE-3-PHASE1_PROPOSAL_MISMATCH: IKEv1: No matching phase 1 proposal
found for peer [chars]
Explanation
There is a IKE policy mismatch for the peer.
Recommended Action
No action is required.
