S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-328
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
IVR Messages
IVR-2
Error Message
IVR-2-AUTOLEARN_ACTION_FAIL: failure happens during constructing
virtual dynamic pfcid table
Explanation
This can happen if failure happens during building, distRIButing or committing the
virtual dynamic pfcid table.
Recommended Action
Please 1. check the fabric connection or 2. check current virtual
user-configured pfcid entries and internally assigned virtual fcid entries for possible conflict.
Error Message
IVR-2-AUTOLEARN_FEATURE_NOT_SUPPORT: some switches:[chars] don't
support autolearn
Explanation
This can happen if some switches do not support the virtual pfcid autolearn feature.
Recommended Action
Please upgrade the unsupported switches.
Error Message
IVR-2-CFS_PEER_LOST_WITHIN_SESSION: CFS peer with switch wwn [chars]
was lost in the middle of an active CFS session. Abort the CFS session and re-enter
the configuration changes
Explanation
Due to port flaps, link outages, switch restart etc. a CFS peer switch of IVR was lost.
The current configuration changes would not be applied to this peer until the peer merges with this
switch. The CFS merge may fail if the configuration at the lost peer conflicts with the changes made
in this session. Also, IVR auto topology could be out of sync. with this peer. It is recommended that
the user abort this CFS session using ivr abort command and then re-enter the configuration changes.
Recommended Action
No action is required.
Error Message
IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices
Explanation
Failed to program FCID rewrite entries probably because the hardware ran out of FCID
rewrite entries. This can happen if there are too many devices in Inter-VSAN zone or too many local
VSANs in VSAN topology.
Recommended Action
Reduce the number of devices involved in IVR in the active IVR zone set.
Also, reduce the number of redundant transit VSANs, if any.
