S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-775
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message
URIB-5-BOGUS_MASK Format: Client \%s\ tried to add %s/%d
Explanation
A bogus mask was received from the client.
Parameters: Client, Prefix, Prefix Length ...
Recommended Action
Use the 'restart' command to restart the feature and clear this problem.
Error Message
URIB-5-BOGUS_PREFIX Format: \%s\ tried to add %s/%d
Explanation
A bogus prefix was received from the client.
Parameters: Client, Prefix, Prefix Length ...
Recommended Action
Use the 'restart' command to restart the feature and clear this problem.
Error Message
URIB-5-GENERAL_FAILURE Format: Failed to %s
Explanation
The logged action failed, causing an unrecoverable error. ; Recommened action: Use
the 'system switchover' command to switch over to the standby supervisor. If no standby is present,
or the standby is not ready, use the 'reload' command to reload the system. The state of the standby
can be checked using the 'show system redundancy ha status' command.
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message
URIB-5-PATH_DELETE Format: Could not find %s for client \%s\, prefix
%s/%d nexthop %s, %s
Explanation
URIB could not find the path that a client tried to delete.
Parameters: Structure, Client, Prefix, Prefix Length, Next-hop, Interface ...
Recommended Action
No action is required.
Error Message
URIB-5-RES_MGR_CHANGE Format: Changed u4route-mem from (%d, %d) to
(%d, %d)
Explanation
The requested limit-resource command was adapted to fit the limits in this version.
Parameters: Requested Min, Requested Max, New Min, New Max ...
Recommended Action
No action is required.
URIB-6
Error Message
URIB-6-GENERAL_INFO Format: %s
Explanation
Informational message only.
Recommended Action
No action is required.
