Configuring Authentication
Cisco AS5300 Universal Access Server Software Configuration Guide
4-8
Communicating with a RADIUS Server
To enable communication between the RADIUS security (database) server and the access server,
enter the commands listed in Table 4-4.
You can use any of the following optional commands to interact with the RADIUS server host:
•
radius-server retransmit number
This command specifies the number of times that the access server transmits each RADIUS
request to the server before the access server gives up.
•
radius-server timeout seconds
This command specifies the number of seconds that the access server waits for a reply to a
RADIUS request before the access server retransmits the request. The default is 5 seconds. If the
RADIUS server’s response is slow (because of support for a large number of users or large
network latency), increase the timeout value.
For more information about these commands, refer to the Security Command Reference, available
online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/secur_c/
Table 4-4
Establishing Communication with a RADIUS Security Server
Step
Command
Description
1
5300> enable
Password: <password>
5300#
Enter enable mode.
Enter the password.
You have entered enable mode when the
prompt changes to
5300#
.
2
5300# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
Enter global configuration mode. You
have entered global configuration mode
when the prompt changes to
5300(config)#.
3
5300(config)# radius-server host alcatraz
Enter the IP address or host name of the
remote RADIUS server host. This host is
normally a UNIX system running
RADIUS software. In this example, the
host name is alcatraz.
4
5300(config)# radius-server key abra2cad
Specifies a shared secret text string used
between the access server and the
RADIUS server. The access server and
RADIUS server use this text string to
encrypt passwords and exchange
responses. In this example, the shared
secret text string is abra2cad.
5
5300(config)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
5300#
Return to enable mode.
This message is normal and does not
indicate an error.
Summary of Contents for AS5300 - Universal Access Server
