Cisco AS5300 Universal Access Server Software Configuration Guide
Upgrading Modem Code
A-26
To set the modem code mapping to the modem code version bundled with Cisco IOS software, enter
the following command:
Step 1
Enter the access server enable mode (the prompt is displayed as
5300#
):
5300> enable
Password: <password>
5300#
Step 2
Enter the copy
system:/ucode/filename
modem command (or, for Cisco IOS releases
earlier than 11.3AA or 12.0, the copy ios-bundled modem command):
5300# copy system:/ucode/microcom_firmware modem
Modem Numbers (<slot>/<port> | group <number> | all)? 0/0
Copy "system:/ucode/microcom_firmware" to modems? [yes/no]yes
5300#
Mar 11 22:55:38.734: %MODEM-5-DL_START: Modem (0/0) started firmware download
Mar 11 22:57:08.699: %MODEM-5-DL_GOOD: Modem (0/0) completed firmware download:
MNPClass10V.90ModemRev5.0.40/85
This command does not affect any existing modem code that resides in system Flash memory in case
you later want to revert to it. If you decide to delete the code from system Flash memory, remember
that all files in system Flash memory will be deleted, therefore save and restore any important files
(for example, the Cisco IOS software image).
Note
If the new Cisco IOS image contains the same modem code as the old one, no new code will
be downloaded to the modems.
Summary of Contents for AS5300 - Universal Access Server
