-11
Cisco AS5350 Universal Gateway Chassis Installation Guide
78-10754-03 0A
Appendix
Replacing Flash Memory SIMMs
Figure A-7
Removing the Flash Memory SIMM
Caution
Some Flash memory SIMMs have the components mounted on the rear side. To prevent damage when
you insert the SIMM, always use the polarization notch as a reference, not the position of the
components on the SIMM.
Step 8
Insert the new SIMM by sliding the end with the metal fingers into the appropriate SIMM socket at
approximately a 45-degree angle to the system board as shown in Figure A-8.
Figure A-8
Inserting the Flash Memory SIMM
Step 9
Gently rotate the SIMM until the latch on either side snaps into place. Do not use excessive force because
the connector might break. When inserting the new SIMM, make sure that the polarization notch is
located at the right end of the SIMM socket.
35689
35690
45
