3-14
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 3
Basic Configuration Using the Command-Line Interface
Configuring ISDN PRI
Controller Numbering
The CT1/E1 controller numbering convention is dfc-slot/port in CLI commands. Trunk-card slot
numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the
motherboard. CT1/E1 trunk-card slots are numbered sequentially from 1 to 7. Port numbering is from 0
to 7.
The CT3 controller numbering convention is dfc-slot/port in CLI commands. Trunk-card slot numbering
starts from the motherboard and works up from left to right. Slot 0 is reserved for the motherboard.
Trunk-card slots are numbered sequentially from 1 to 7. Port number value is always 0.
Under the CT3, the CT1 controller numbering convention is dfc-slot/port:channel in CLI commands.
Port numbering values range from 1 to 28.
Configure
Channels
23 B + D
Trunk selection sequence
Either ascending order (from 1 to 23) or descending order (from 23 to 1)
B + D glare
Yield
Directory numbers
Only 1 directory number assigned by service provider
SPIDs required?
None
Table 3-2
CT1 Configuration Attributes (continued)
Attribute
Value
Command Purpose
Step 1
AS5400> enable
Password: password
AS5400#
Enters enable mode. Enters the password. You are
in enable mode when the prompt changes to
AS5350#
or
AS5400#
.
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
or
AS5400(config)#.
Step 3
AS5400(config)# isdn switch-type
switch-type
Selects a service provider switch type that
accommodates PRI. (Refer to
Table 3-3
for a list
of supported switch type keywords.)
