3-30
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 3
Basic Configuration Using the Command-Line Interface
Configuring the Universal Port Card and Lines
SPE SPE SPE SPE Port Call
SPE# Port # State Busyout Shut Crash State Type
4/00 0000-0005 ACTIVE 0 0 0 ______ ______
4/01 0006-0011 ACTIVE 0 0 0 ______ ______
4/02 0012-0017 ACTIVE 0 0 0 ______ ______
4/03 0018-0023 ACTIVE 0 0 0 ______ ______
4/04 0024-0029 ACTIVE 0 0 0 ______ ______
.
.
.
•
Enter the show line number command to display a summary for a single line:
AS5400# show line 1
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1 AUX 9600/9600 - - - - - 0 0 0/0 -
Ready
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits
Status: Ready
Capabilities: none
Modem state: Ready
Group codes: 0
Modem hardware state: noCTS noDSR DTR RTS
TTY NUMBER 1
Parity Error = 0 Framing Error = 0 Receive Error = 0 Overrun = 0
Outcount = 0 totalout = 39 incount = 0 totalin = 0
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
Tip
If you are having trouble, make sure you turned on the protocols for connecting to the lines (transport
input all) and configured for incoming and outgoing calls (modem inout).
