Basic Configuration Using the Command-Line Interface
Configuring T1 and E1 Feature Cards
9
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
•
Mix and match channels supporting ISDN PRI, channel grouping, and robbed-bit signaling across
the same T1 line. For example, on the same channelized T1 you can configure the
pri-group
timeslots 1-10,24
command,
channel-group 11 timeslots 11-16
command, and
ds0-group 17
timeslots 17-23 type e&m-fgb
command. This is an unusual configuration because it requires you
to align the correct range of timeslots on both ends of the connection.
Note
For configuration information about leased-line or nondial use, see the
Cisco IOS Configuration
Fundamentals Configuration Guide
for your software release.
Note
You can install a maximum of two T1 feature cards, two E1 feature cards, or one channelized T3 (CT3)
feature card in a single Cisco AS5350XM or Cisco AS5400XM chassis.
Controller Numbering
The T1 and E1 controller numbering convention is
slot/port
in CLI commands. Feature card slot
numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the
motherboard. T1 or E1 feature card slots are numbered sequentially from 1 to 7. Port numbering is from
0 to 7.
Configure
Command
Purpose
Step 1
AS5400>
enable
Password:
password
AS5400#
Enters enable mode. Enters the password. You
have entered enable mode when the prompt
changes to
AS5350#
or
AS5400#
.
Step 2
AS5400#
configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
or
AS5400(config)#.
Step 3
AS5400(config)#
controller
[
t1
|
e1
]
slot/port
AS5400(config-controller)#
Enters controller configuration mode to configure
your controller slot and port. Slot values range
from 1 to 7. Port values range from 0 to 7 for T1
and E1.
Step 4
AS5400(config-controller)#
framing esf
Enters the telco framing type:
esf
or
sf
.
Step 5
AS5400(config-controller)#
linecode b8zs
Enters the telco line code type:
ami
or
b8zs
.
Step 6
AS5400(config-controller)#
Ctrl-Z
AS5400#
Returns to enable mode.