Basic Configuration Using the Command-Line Interface
Configuring DS0 Trunk Group Dial Out
21
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Step 2
Configure the trunk group label.
AS5400(config)#
interface Serial3:23
AS5400(config-if)#
no ip address
AS5400(config-if)#
trunk-group PRI-TRUNK-GROUP
Note
The
timeslots
option is
not
available in the serial interface configuration mode, because a serial
interface may represent an NFAS serial interface.
Step 3
Configure timeslots and preference.
AS5400(config)#
controller T1 3
AS5400(config-controller)#
framing esf
AS5400(config-controller)#
clock source line secondary 3
AS5400(config-controller)#
linecode b8zs
AS5400(config-controller)#
pri-group timeslots 1-24
AS5400(config-controller)#
trunk-group PRI-TRUNK-GROUP-1 timeslots 1-10
AS5400(config-controller)#
trunk-group PRI-TRUNK-GROUP-2 timeslots 11-15
AS5400(config-controller)#
trunk-group PRI-TRUNK-GROUP-3 timeslots 20-22 preference 10
Note
When a PRI or NFAS trunk is fractionally added to a trunk group, the
timeslots
keyword is
compulsory.
Verify
Use the
show trunk group
command to display the DS0 lines that belong to a particular trunk group.
A trunk group can be a group of DS0 lines from various signaling channels.
AS5400#
show trunk group pri-tg
Trunk group: pri-tg
Description:
trunk group label: pri-tg
Translation profile (Incoming):
Translation profile (Outgoing):
Hunt Scheme is least-used
Max Calls (Incoming): NOT-SET (Any) NOT-SET (Voice) NOT-SET (Data)
Max Calls (Outgoing): NOT-SET (Any) NOT-SET (Voice) NOT-SET (Data)
Retries: 0
Trunk 2/1:23 Preference 10
Channels : 1-23
Total channels available : 23
Data = 0, Voice = 0, Modem = 0, Pending = 0, Free = 23
Total calls for trunk group: Data = 0, Voice = 0, Modem = 0
Pend = 0, Free = 23
advertise_flag 0x00000040, capacity timer 25 sec tripl_config_mask 0x00000000
AC_curr 24, FD_curr 0, SD_curr 0
succ_curr 0 tot_curr 0
succ_report 0 tot_report 0
changed 0 replacement position 0