Basic Configuration Using the Command-Line Interface
Configuring the Universal Port and Dial-Only Feature Cards
28
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Verify
To verify your SPE configuration, use these commands.
•
Enter the
show spe
command to display a summary for all the lines:
AS5400#
show spe
SPE settings:
==============
Country code configuration: default T1 (u Law)
Polling interval: 8 secs.
History log events: 50(per port)
Port legends:
============
Port state: (s)shutdown (t)test (r)recovery (d)download
(b)busiedout (p)busyout pending, (B)bad (a)active call
Call type: (m)modem (d)digital (f)fax-relay (v)voice (_)not in use
System resources summary:
======================
Total ports: 108, in use ports: 0, disabled ports: 0, free ports: 108
Total active calls: modem 0, voice 0, digital 0, fax-relay 0
SPE SPE SPE SPE Port Call
SPE# Port # State Busyout Shut Crash State Type
4/00 0000-0005 ACTIVE 0 0 0 ______ ______
4/01 0006-0011 ACTIVE 0 0 0 ______ ______
4/02 0012-0017 ACTIVE 0 0 0 ______ ______
4/03 0018-0023 ACTIVE 0 0 0 ______ ______
4/04 0024-0029 ACTIVE 0 0 0 ______ ______
.
.
.
•
Enter the
show line
number
command to display a summary for a single line:
AS5400#
show line 1
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1 AUX 9600/9600 - - - - - 0 0 0/0 -
Ready
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits
Status: Ready
Capabilities: none
Modem state: Ready
Group codes: 0
Modem hardware state: noCTS noDSR DTR RTS
TTY NUMBER 1
Parity Error = 0 Framing Error = 0 Receive Error = 0 Overrun = 0
Outcount = 0 totalout = 39 incount = 0 totalin = 0
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
