3-3
Cisco ASA 5550 Getting Started Guide
78-17644-01
Chapter 3 Installing the Cisco ASA 5550 Security Appliance
Installing the Chassis
Installing the Chassis
This section describes how to rack-mount and install the adaptive security
appliance. You can mount the adaptive security appliance in a 19-inch rack (with
a 17.5- or 17.75-inch opening).
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must
take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety.
The following information can help plan equipment rack installation:
•
Allow clearance around the rack for maintenance.
•
When mounting a device in an
enclosed rack ensure adequate ventilation. An
enclosed rack should never be overcrowded.
Make sure that the rack is not
congested, because each unit generates heat.
•
When mounting a device in an open rack, make sure that the rack frame does
not block the intake or exhaust ports.
•
If the rack contains only one unit, mount the unit at the bottom of the rack.
•
If the rack is partially filled, load the rack from the bottom to the top, with the
heaviest component at the bottom of the rack.
•
If the rack contains stabilizing devices, install the stabilizers prior to
mounting or servicing the unit in the rack.
Warning
Before performing any of the following procedures, ensure that the power
source is off. (AC or DC). To ensure that power is removed from the DC circuit,
locate the circuit breaker on the panel board that services the DC circuit,
switch the circuit breaker to the OFF position, and tape the switch handle of the
circuit breaker in the OFF position.
