4-29
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
OL-22567-02
Chapter 4 Maintenance and Upgrade Procedures
Installing a Slide Rail Kit
Step 3
Install the new fan module by aligning it with the fan module bay and pushing it into place until it
is seated.
Step 4
Tighten the captive screws.
Step 5
Verify that the fan indicator on the lower right-hand of the back panel is green.
Installing a Slide Rail Kit
Before installing the appliance in a rack-mount slide rail, you must install the slide rail kit hardware.
Note
The slide rail kit hardware ships with the ASA 5585-X.
To install the slide rail kit hardware on the ASA 5585-X, follow these steps:
Step 1
Power off the appliance.
Step 2
Remove the power cable from the appliance.
Step 3
If your appliance has the fixed cable-management brackets, do the following:
a.
Remove the cable-management brackets from the front sides of the appliance.
b.
Remove the appliance from the rack.
c.
Remove the front brackets, left and right side brackets, and left and right rear brackets from
the appliance.
1
Fan module and module handle
2
Fan module screw
3
Power supply module
Cisco ASA 1200W A
C
100-240V
15.0/8.0.A
56/60Hz
IN
OK FA
N
OK
OUT
FAIL
253910
Cisco-ASA-F
AN
Cisco-ASA-F
AN
2
1
2
3