•
PCMCIA device
•
Nand Flash (used to store SMC firmware)
•
Hard drive
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 55: SMC Busy LED States
Troubleshooting
Description
Color
No maintenance needed.
Data is being read from
or written to one of the
memory devices.
Green/
Blinking
Green
NOTE:
If you are removing an SMC from the chassis, it is
recommended that you wait until this LED is off to ensure the
integrity of all data being transferred to or from the memory
device.
No maintenance needed.
The memory devices are
not in use.
None
Checking the LEDs on Packet Processing Cards
Each packet processing card is equipped with status LEDs as shown in the following figure:
•
Run/Fail
•
Active
•
Standby
•
Status
•
Service
ASR 5000 Installation Guide
144
Applying Power and Verifying the Installation
Checking the LEDs on Packet Processing Cards
Summary of Contents for ASR 5000
