Table 56: Packet Processing Card Run/Fail LED States
Troubleshooting
Description
Color
None needed.
Card powered with no
errors detected
Green
None needed.
Card is initializing and/or
loading software
Blinking
Green
Errors were detected during the POSTs. It is likely that the errors
were logged to the system's command line interface during the
boot process.
Card powered with
error(s) detected
Red
Verify that the POWER LEDs on the PFUs are green. If they are
not, refer to
Checking the LED on the PFU, on page 137
for
troubleshooting information.
Card is not receiving
power
None
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
this document.
If all of the above suggestions have been verified, it is possible
that the packet processing card is not functional. Please contact
your service representative.
PSCA, PSC2, PSC3 and PPC Active LED States
The Active LED on the packet processing card indicates that the software is loaded on the card and that the
card is ready for operation. When the system first boots up, all installed packet processing cards are booted
into standby mode. You must then configure the system to designate which packet processing cards are to
serve as redundant components (in standby mode) and which are to function as active components.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 57: Packet Processing Card Active LED States
Troubleshooting
Description
Color
The first time power is applied to the system, all of the packet
processing cards should be booted into the standby mode.
Therefore, this LED should be off.
Card is active
Green
ASR 5000 Installation Guide
146
Applying Power and Verifying the Installation
Checking the LEDs on Packet Processing Cards
Summary of Contents for ASR 5000
