L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Verify that the port configuration settings are correct by entering the following command:
show configuration port slot#/port#
slot#
is the chassis slot number of the line card where the physical port resides. slot# is either 24 or 25.
port#
is the number of the port (either 1 or 2).
This
show
command produces an output similar to the one shown below. It displays the configuration of port
2 of the SPIO installed in chassis slot 24. In this example, the port is bound to an interface called
mgmt2
.
config
port ethernet 24/2
description management2
no shutdown
bind interface mgmt2 local
#exit
end
Save your configuration as described in
Verifying and Saving Your Configuration
.
Configuring System Timing
The system is equipped with a clock that supplies the timestamp for statistical counters, accounting records,
logging, and event notification. After the initial configuration of the system clock, you can configure the
system to communicate with one or more Network Time Protocol (NTP) server(s) to ensure that the clock is
always accurate.
In the event of a power outage, the clock is maintained with an accuracy of +/- one minute per month for up
to 10 years. This ensures that when power is restored, the system is ready to process sessions and generate
accounting, log, and event data with accurate timestamps.
In addition to configuring the timing source, you must configure the system's time zone.
Setting the System Clock and Time Zone
Use the following command example to configure the system clock and time zone:
clock set date
:
time
configure
clock timezone timezone
[
local
]
end
Notes:
•
Enter the date and time in the format YYYY:MM:DD:HH:mm or YYYY:MM:DD:HH:mm:ss.
•
Refer to the online Help for the
clock timezone
command for a complete list of supported time zones.
•
The optional
local
keyword indicates that the time zone specified is the local timezone.
•
Daylight Savings Time is automatically adjusted for time zones supporting it.
Save your configuration as described in
Verifying and Saving Your Configuration
.
ASR 5000 System Administration Guide, StarOS Release 21.1
39
System Settings
Configuring System Timing
Summary of Contents for ASR 5000
Page 26: ...ASR 5000 System Administration Guide StarOS Release 21 1 xxvi Contents ...
Page 316: ...ASR 5000 System Administration Guide StarOS Release 21 1 288 VLANs VLAN Related CLI Commands ...
Page 400: ...ASR 5000 System Administration Guide StarOS Release 21 1 372 Engineering Rules ECMP Groups ...