PDN Gateway Configuration
▀ Configuring the System as a Standalone PMIP P-GW in an LTE-SAE Network
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
142
Required
Information
Description
Physical port
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
address
Used when configuring static IP routes from the interface(s) to a specific network.
Rf Diameter Endpoint Configuration
End point name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the Rf Diameter endpoint
configuration is recognized by the system.
Origin realm
name
An identification string between 1 through 127 characters.
The realm is the Diameter identity. The originator’s realm is present in all Diameter messages and is typically
the company or service name.
Origin host name
An identification string from 1 to 255 characters (alpha and/or numeric) by which the Rf origin host is
recognized by the system.
Origin host
address
The IP address of the Rf interface.
Peer name
The Rf endpoint name described above.
Peer realm name
The Rf origin realm name described above.
Peer address and
port number
The IP address and port number of the PCRF.
Route-entry peer
The Rf endpoint name described above.
How This Configuration Works
The following figure and supporting text describe how this configuration with a single source and destination context is
used by the system to process a subscriber call originating from the PMIP LTE network.
