PDN Gateway Configuration
▀ Configuring the System as a Standalone PMIP P-GW Supporting an eHRPD Network
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
158
Required
Information
Description
Security
administrator
password
Open or encrypted passwords can be used.
Remote access
type(s)
The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
Required P-GW Context Configuration Information
The following table lists the information that is required to configure the P-GW context on a P-GW.
Table 18.
Required Information for P-GW Context Configuration
Required
Information
Description
P-GW context
name
An identification string from 1 to 79 characters (alpha and/or numeric) by which the P-GW context will be
recognized by the system.
Accounting
policy name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy will be
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
S2a Interface Configuration (To/from HSGW)
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface will be
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
subnet
IPv6 addresses assigned to the interface.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
address
Used when configuring static IP routes from the interface(s) to a specific network.
P-GW Service Configuration
P-GW service
name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the P-GW service will be
recognized by the system.
Multiple names are needed if multiple P-GW services will be used.
PLMN ID
MCC number: The mobile country code (MCC) portion of the PLMN’s identifier (an integer value between
100 and 999).
MNC number: The mobile network code (MNC) portion of the PLMN’s identifier (a 2 or 3 digit integer value
between 00 and 999).
LMA Service Configuration
