Gx Interface Support
▀ Rel. 7 Gx Interface
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
284
Terminology and Definitions
This section describes features and terminology pertaining to Rel. 7 Gx functionality.
Policy Control
The process whereby the PCRF indicates to the PCEF how to control the IP-CAN bearer.
Policy control comprises the following functions:
Binding:
Binding is the generation of an association between a Service Data Flow (SDF) and the IP CAN bearer
(for GPRS a PDP context) transporting that SDF.
The QoS demand in the PCC rule, as well as the SDF template are input for the bearer binding. The selected
bearer will have the same QoS Class as the one indicated by the PCC rule.
Depending on the type of IP-CAN and bearer control mode, bearer binding can be executed either by the
PCRF, or both PCRF and PCEF.
For UE-only IP-CAN bearer establishment mode, the PCRF performs bearer binding. When the PCRF
performs bearer binding, it indicates the bearer (PDP context) by means of Bearer ID. The Bearer ID
uniquely identifies the bearer within the PDP session.
For UE/NW IP-CAN bearer establishment mode, the PCRF performs the binding of the PCC rules for
user controlled services, while the PCEF performs the binding of the PCC rules for the network-
controlled services.
Gating Control:
Gating control is the blocking or allowing of packets, belonging to an SDF, to pass through to
the desired endpoint. A gate is described within a PCC rule and gating control is applied on a per SDF basis.
The commands to open or close the gate leads to the enabling or disabling of the passage for corresponding IP
packets. If the gate is closed, all packets of the related IP flows are dropped. If the gate is opened, the packets
of the related IP flows are allowed to be forwarded.
Event Reporting
: Event reporting is the notification of and reaction to application events to trigger new
behavior in the user plane as well as the reporting of events related to the resources in the Gateway (PCEF).
Event triggers may be used to determine which IP-CAN session modification or specific event causes
the PCEF to re-request PCC rules. Although event trigger reporting from PCEF to PCRF can apply for
an IP CAN session or bearer depending on the particular event, provisioning of event triggers will be
done at session level.
Note that in 11.0 and later releases, RAR with unknown event triggers are silently ignored and
responded with DIAMETER_SUCCESS. In earlier releases, when unknown event triggers were
received in the RAR command from PCRF, invalid AVP result code was set in the RAA command.
The Event Reporting Function (ERF) receives event triggers from PCRF during the Provision of PCC
Rules procedure and performs event trigger detection. When an event matching the received event
trigger occurs, the ERF reports the occurred event to the PCRF. If the provided event triggers are
associated with certain parameter values then the ERF includes those values in the response back to
the PCRF. The Event Reporting Function is located in the PCEF.
In StarOS releases prior to 14.0, SUCCESSFUL_RESOURCE_ALLOCATION ( 22 ) event trigger
was sent for rules irrespective of successful installation. In 14.0 and later releases,
SUCCESSFUL_RESOURCE_ALLOCATION ( 22 ) event trigger will be sent under the following
conditions:
When a rule is installed successfully (and the event trigger is armed by PCRF and resource-
allocation-notification is enabled).
