dsu remote
To control the bandwidth usage with the remote port, use the
dsu remote
command in T3 or E3 configuration
mode. To return to the default state, use the
no
form of this command.
dsu remote
{
disable| fullrate
}
no dsu remote
Syntax Description
Denies incoming remote requests to reset the bandwidth to the full rate.
disable
Requests that the remote port set its bandwidth to full rate.
fullrate
Command Default
Remote accept is the default.
Command Modes
T3 configuration
E3 configuration
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Support for E3 configuration mode was added.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To verify the DSU remote settings configured on the interface, use the
show controllers t3
command in
EXEC mode.
Task ID
Operations
Task ID
read, write
sonet-sdh
Examples
The following example shows how to specify that the connected remote port set its bandwidth to full rate:
RP/0/RSP0/CPU0:router(config)#
controller t3 0/6/2/0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
998
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
dsu remote
