Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the
show controllers t3
command to display MDL information (received strings). MDL information is
displayed only when framing is set to C-bit.
MDL is supported only when the DS3 framing is C-bit parity.
Note
Task ID
Operations
Task ID
read, write
sonet-sdh
Examples
The following example shows the
mdl
commands on a T3 controller in slot 1, subslot 2, port 0:
RP/0/RSP0/CPU0:router(config)#
controller t3 0/1/2/0
RP/0/RSP0/CPU0:router(config-t3)#
clock source line
RP/0/RSP0/CPU0:router(config-t3)#
mdl string eic ID
RP/0/RSP0/CPU0:router(config-t3)#
mdl string fic Building B
RP/0/RSP0/CPU0:router(config-t3)#
mdl string unit ABC
RP/0/RSP0/CPU0:router(config-t3)#
mdl string fi Facility Z
RP/0/RSP0/CPU0:router(config-t3)#
mdl string port-number Port 7
RP/0/RSP0/CPU0:router(config-t3)#
mdl transmit path enable
RP/0/RSP0/CPU0:router(config-t3)#
mdl transmit idle-signal enable
Related Commands
Description
Command
Displays information about the T3 links and hardware and software
drivers for the T3 controller.
show controllers t3, on page 1054
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1028
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
mdl