•
The following list describes the components of the notation:
◦
rack
—
Chassis number of the rack.
◦
slot
—
Physical slot number of the line card.
◦
module
—
Module number or subslot (for a SPA). A physical layer interface module (PLIM) is
always 0.
◦
port
—
Physical port number of the interface.
◦
T3num
—
T3 controller number.
◦
T1num
—
T1 controller number.
Task ID
Operations
Task ID
read
sonet-sdh
Examples
The following example shows sample output from the
show controllers t1 lnm
command with the
all
keyword
for a single T1 channel:
RP/0/RSP0/CPU0:router#
show controllers t1 0/1/1/0/1/1 lnm all
Thu May 13 10:28:26.474 PDT
Controller T1 0/1/1/0/1/1
Syslog
Monitoring type
State
Thresholds (lcv/pcv/duration)
--------------------------------------------------------------------
enabled
minor-warning
stable
Set(
15/
15/
4) Clear(
15/
15/
4)
major-warning
stable
Set( 154/ 145/
4) Clear( 154/ 145/
4)
Monitoring type
Minor-Warn
Major-Warn
---------------
------------
------------
Create
1
1
Update
0
0
Delete
0
0
Clear
0
0
Noise Crossed
1
1
Noise Cleared
1
1
Last Five Events
--------------------------------------------------------------------
MINWARNCROSS: Noise crossed minor-warn threshold at Thu May 13 09:54:10 2010
MAJWARNCROSS: Noise crossed major-warn threshold at Thu May 13 09:54:11 2010
MAJWARNCLEAR: Noise cleared major-warn threshold at Thu May 13 10:27:25 2010
MINWARNCLEAR: Noise cleared minor-warn threshold at Thu May 13 10:28:14 2010
The following example shows sample output from the
show controllers t1 lnm
command with the
configuration
keyword for a single T1 channel:
This is also the default output that is displayed if you run the
show controllers lnm
command without
specifying any keyword options.
Note
RP/0/RSP0/CPU0:router#
show controllers t1 0/1/1/0/1/1 lnm configuration
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1043
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
show controllers lnm
