delay trigger
To configure a time value for the Synchronous Transport Signal (STS) path delay trigger, use the
delay trigger
command in STS path configuration mode. To return the command to its default setting, use the
no
form of
this command.
delay trigger value
no delay trigger value
Syntax Description
Value, in milliseconds, for the STS path delay trigger. The range is from 0 through 60000.
The default is 0 seconds, which means that there is no delay.
value
Command Default
The default is 0 seconds, which means that there is no delay.
Command Modes
STS path configuration
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If the timer for the STS path delay trigger expires, an alarm is declared.
Task ID
Operations
Task ID
read, write
sonet-sdh
Examples
The following example shows how to set the STS path delay trigger to 6000 milliseconds:
RP/0/RSP0/CPU0:router(config)#
controller sonet 0/2/0/3
RP/0/RSP0/CPU0:router(config-sonet)#
sts 1
RP/0/RSP0/CPU0:router(config-stsPath)#
delay trigger 6000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
861
SONET Controller Commands on the Cisco ASR 9000 Series Router
delay trigger
