Description
Field
Trace identifier mismatch. Reported TIM defects that
occur primarily as a result of provisioning errors; for
example, incorrect cross-connections in the network.
TIM
Line triggers delayed and cleared, in milliseconds.
Line delays trigger
Path triggers delayed and cleared, in milliseconds.
Path delays trigger
When the counters associated with the
show
controllers sonet
command were last cleared.
Last clearing of
“
show controllers SONET
”
counters
Any alarms detected by the controller are displayed
here. Alarms are as follows:
•
Transmitter is sending remote alarm.
•
Transmitter is sending AIS.
•
Receiver has loss of signal.
•
Receiver is getting AIS.
•
Receiver has loss of frame.
•
Receiver has remote alarm.
•
Receiver has no alarms.
Detected/Asserted Alarms
Masked alarms for the asserted alarm. For example,
when SLOS is asserted, all low-level alarms are
masked and are listed in this section of the output.
Mask for Detected -> Asserted
List of alerts that are detected.
Detected Alerts
List of reported alerts, such as B1-TCA B2-TCA
B3-TCA, sent to the application layer.
Reported Alerts
List of masked alerts for asserted alarms that are
reported.
Mask for Detected -> Reported
Types of alarms that generate an alarm message.
Alarm reporting enabled for
Types of alarms that generate an alert message.
Alert reporting enabled for
Type of framing enabled on the controller.
Framing
Status of synchronous payload envelope (SPE)
scrambling: Enabled, Disabled.
SPE Scrambling
Value extracted from the SONET path signal label
byte (C2).
C2 State
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
910
SONET Controller Commands on the Cisco ASR 9000 Series Router
show controllers sonet
