clear controller t1
To clear T1 controller data, use the
clear controller t1
command in EXEC configuration mode.
clear controller t1 interface-path-id
Syntax Description
Physical interface or virtual interface.
Use the
show controllers
command to see a list of all controllers currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (
?
) online
help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When specifying a channelized T1 controller, use the following guidelines for the
interface-path-id
:
•
The naming notation is
rack
/
slot
/
module
/
port
/
T3Num
/
T1num
.
•
The slash between values is required as part of the notation.
•
The following list describes the components of the notation:
◦
rack
—
Chassis number of the rack.
◦
slot
—
Physical slot number of the line card.
◦
module
—
Module number or subslot (for a SPA). A physical layer interface module (PLIM) is
always 0.
◦
port
—
Physical port number of the interface.
◦
T3num
—
T3 controller number.
◦
T1num
—
T1 controller number.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
962
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
clear controller t1
