show controllers t1
To display information about the T1 links and hardware and software drivers for the T1 controller, use the
show controllers t1
command in EXEC mode.
show controllers t1 interface-path-id
[
all| bert| brief| internal-state
|
remote
{
performance brief| tabular
}
|
tabular
]
Syntax Description
Physical interface or virtual interface.
Use the
show interfaces
command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(
?
) online help function.
interface-path-id
Displays all information for the controllers.
all
Displays internal T1 bit error rate test results.
bert
Displays summary information for the T1 controller.
brief
Displays internal T1 state information.
internal-state
Displays remote performance information in a brief summary or table format.
remote
{
performance brief
|
tabular
}
Displays T1 controller information in table format.
tabular
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When specifying a channelized T1 controller, use the following guidelines for the
interface-path-id
:
•
The naming notation is
rack
/
slot
/
module
/
port
/
T3Num
/
T1num
.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1046
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
show controllers t1
