action dying-gasp
To configure what action is taken on an interface when a dying-gasp notification is received from the remote
Ethernet OAM peer, use the
action dying-gasp
command in Ethernet OAM configuration mode or interface
Ethernet OAM configuration mode. To return to the default, use the
no
form of this command.
action dying-gasp
{
disable| error-disable-interface| log
}
no action dying-gasp
{
disable| error-disable-interface| log
}
Syntax Description
Performs no action on the interface when a dying-gasp notification is received.
disable
Puts the interface into the error-disable state when a dying-gasp notification is
received.
error-disable-interface
(Interface Ethernet OAM configuration only) Creates a syslog entry when a
dying-gasp notification is received. This action is available only in interface
Ethernet OAM configuration mode to override the OAM profile on a specific
interface.
log
Command Default
The default action is to create a syslog entry.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Operations
Task ID
read, write
ethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
141
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
action dying-gasp
