path delay clear
To configure the amount of time before a SONET/SDH path delay trigger alarm is cleared, use the
path delay
clear
command in SONET controller configuration mode. To return the command to its default setting, use
the
no
form of this command.
path delay clear value
no path delay clear
Syntax Description
Value, in milliseconds, before a SONET/SDH path delay trigger alarm is cleared. The
range is 1000 to 180000. The default is 10 seconds.
value
Command Default
The default is 10 seconds.
Command Modes
SONET controller configuration
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Operations
Task ID
read, write
sonet-sdh
Examples
The following example shows how to specify that SONET/SDH path delay trigger alarms should be cleared
after 7000 milliseconds:
RP/0/RSP0/CPU0:router(config)#
controller SONET 0/0/0/1
RP/0/RSP0/CPU0:router(config-sonet)#
path delay clear 7000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
880
SONET Controller Commands on the Cisco ASR 9000 Series Router
path delay clear
