show aps group
To display information about the automatic protection switching (APS) groups, use the
show aps group
command in EXEC mode.
show aps group
[
number
]
Syntax Description
(Optional) The assigned group number.
number
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The
show aps group
command displays information about APS groups, and is useful if multiple APS groups
are configured.
Displaying the APS operational data is considered of lower priority than the APS operation itself. Because
the information is collected from several sources scattered across the various nodes involved, there is a small
probability that some states will change while the command is being run.
The command should be reissued for confirmation before decisions are made based on the results displayed.
Task ID
Operations
Task ID
read
sonet-sdh
Examples
The following is sample output from the
show aps group
command:
RP/0/RSP0/CPU0:router#
show aps group 3
APS Group 3:
PGP:Authentication "cisco", hello timeout 1 sec, hold timeout 3 sec
Protect ch 0 (SONET3_1):Admin Down, Disabled
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
897
SONET Controller Commands on the Cisco ASR 9000 Series Router
show aps group
