show controllers sonet
To display information about the operational status of SONET layers, use the
show controllers sonet
command
in EXEC mode.
show controllers sonet interface-path-id
{
all| framers| internal-state
}
Syntax Description
Physical interface or virtual interface.
Use the
show interfaces
command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(
?
) online help function.
interface-path-id
Displays all information.
all
Displays framer information.
framers
Displays internal SONET state.
internal-state
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the
interface-path-id
argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is
rack
/
slot
/
module
/
port
. The slash between values
is required as part of the notation. An explanation of each component of the naming notation is as follows:
◦
rack
: Chassis number of the rack.
◦
slot
: Physical slot number of the line card.
◦
module
: Module number. A physical layer interface module (PLIM) is always 0.
◦
port
: Physical port number of the interface.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
906
SONET Controller Commands on the Cisco ASR 9000 Series Router
show controllers sonet
