8-30
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-09
Chapter 8 Cisco ASR 1002 Router Overview and Installation
Cisco ASR 1002 Router Power Supplies
Management Ethernet Port Cable Connection
Caution
To comply with Class A emissions requirements, a shielded Ethernet cable must be used for the
connection.
To use the Management Ethernet interface on the router, perform the following steps:
Step 1
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see
Figure 8-21
).
Figure 8-21
Cisco ASR 1002 Router Embedded ASR1000-RP1 Management Port Connector
Step 2
Insert the other end of the RJ-45 cable to your management device or network.
Cisco ASR 1002 Router Power Supplies
This section describes the Cisco ASR 1002 Router power supplies and how to connect them:
•
Connecting AC Input Power to Cisco ASR 1002 Router, page 8-31
•
Connecting –48 VDC Input Power to Cisco ASR 1002 Router, page 8-34
•
Connecting Cisco +24 VDC Power Supply, page 8-38
Read the safety warnings before you begin.
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
1
MGMT - management port and cable
280286
ASR 1002
stat
pwr
min
maj
crit
0
1
C
/A
A
/L
0
1
C/
A
A/
L
STAT
QE0
QE1
QE2
QE3
BOOT
CARRIE
R
LINK
PWR ST
AT
MTS
MGMT
AUX
CON
SPA-4XOC
3-POS
S
T
AT
U
S
0
1
2
3
C
/A
A
/L
C
/A
A
/L
C/A
A
/L
C
/A
A
/L
1
