6-11
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
cable-modem downstream saved channel
cable-modem downstream saved channel
To modify the saved downstream channel setting and upstream power value on the cable interface, use
the
cable-modem downstream saved channel
command in cable interface configuration mode. To
remove the saved settings, which will be saved at the next initialization cycle, use the
no
form of this
command.
Cisco uBR904, uBR924 cable access routers
cable-modem downstream saved channel
ds-frequency us-power
no cable-modem downstream saved channel
ds-frequency us-powe
r
Note
Cisco IOS Release 12.1(2)T removed this command from the CLI for all platforms and reserved it for
exclusive use by the DOCSIS provisioning process.
Syntax Description
Defaults
Enabled
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command is auto-generated by the operation of the cable MAC layer process. The DOCSIS RFI
specification requires that CMs remember the downstream frequency and upstream power of the last
successfully ranged session. These arguments are called up as the first downstream frequency and
upstream power to use the next time the CM is booted. This operation dramatically speeds up the channel
search.
Use the
no cable-modem downstream saved channel
ds-frequency us-power
command to remove the
saved frequency and power setting from the running configuration, which will be saved at the next
initialization cycle.
ds-frequency
Downstream channel frequency in Hz, which can be from 91,000,000 to
860,000,000.
us-power
Upstream power level in decibels per millivolt (dBmV), which can be from 8 to
61.
Release
Modification
11.3(4)NA
This command was introduced for the Cisco uBR904 cable access router.
12.0(4)XI1
Support was added for the Cisco uBR924 cable access router.
12.1(2)T
This command was removed from the CLI for all platforms and reserved for
exclusive use by the DOCSIS provisioning process.