6-18
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
cable-modem voip best-effort
cable-modem voip best-effort
To allow voice calls to be sent upstream over the cable interface using best-effort quality of service
(QoS), use the
cable-modem voip best-effort
command in cable interface configuration mode. To
disable best-effort voice calls, use the
no
form of this command.
Cisco uBR924 cable access router
cable-modem voip best-effort
no
cable-modem voip best-effort
Note
Cisco IOS Release 12.1(2)T removed this command from the CLI for all platforms and reserved it for
exclusive use by the DOCSIS provisioning process.
Syntax Description
This command has no arguments or keywords.
Defaults
Enabled
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command allows you to configure the voice traffic on a router to allow only calls having a
high-priority service identifier (SID) to be connected.
If the dynamic configuration of high-priority queues for voice traffic fails, or if the far end cannot
support the multiple SIDs and multiple classes of service required by high-priority traffic, the flag set
by this command will be checked. If enabled (the default setting), the call will be allowed to go through.
If disabled, the call will fail.
Examples
The following example shows how to disable best-effort voice calls:
Router(config)#
interface cable-modem 0
Router(config-if)#
no cable-modem voip best-effort
Router(config-if)#
Release
Modification
11.3(4)NA
This command was introduced for the Cisco uBR904 cable access router.
12.0(4)XI1
Support was added for the Cisco uBR924 cable access router.
12.1(2)T
This command was removed from the CLI for all platforms and reserved for
exclusive use by the DOCSIS provisioning process.