6-57
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
ip http cable-monitor
ip http cable-monitor
To enable the cable access router’s onboard Cable Monitor web server, use the
ip http cable-monitor
command in global configuration mode. To disable the Cable Monitor and turn off all access to the
onboard Cisco web server, use the
no
form of this command.
Cisco uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
ip http cable-monitor
{
basic
|
advance
} [
url-ip-address url-mask
]
no ip http cable-monitor
Syntax Description
Defaults
For
url-ip-address
, 192.168.100.1
For
url-mask
, 255.255.255.0
Command Modes
Global configuration
Command History
Usage Guidelines
This command enables the Cable Monitor, an onboard web server that displays current status,
troubleshooting, and performance information. The Cable Monitor can be accessed in two ways:
basic
Displays only the basic status and performance pages.
advance
Displays all status and diagnostic pages.
Note
The Cable Monitor should not be used in advanced mode without
first implementing a secure password strategy on the cable access
router. Enabling the Cable Monitor in advanced mode without
setting an encrypted enabled password could provide information
that would allow remote users to change the router’s configuration.
url-ip-address
(Optional) Specifies the IP address for the Cable Monitor. This argument,
along with the
url-mask
argument, also defines the network that provides
the IP address pool used by the temporary DHCP server when the cable
interface goes down.
url-mask
(Optional) Specifies the subnet mask for the Cable Monitor. This argument,
along with the
url-ip-address
argument, also defines the network that
provides the IP address pool used by the temporary DHCP server when the
cable interface goes down.
Release
Modification
12.1(1)T
This command is introduced for the Cisco uBR924 cable access router.
12.1(3)XL
Support was added for the Cisco uBR905 cable access router.
12.1(5)XU1
Support was added for the Cisco CVA122 Cable Voice Adapter.
12.2(2)XA
Support was added for the Cisco uBR925 cable access router.
