6-129
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
show controllers cable-modem service-flows
show controllers cable-modem service-flows
To display the service flows that are configured on the router, use the
show controllers cable-modem
service-flows
command in privileged EXEC mode.
Cisco uBR905, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
show controllers cable-modem
number
service-flows
[
sfid
|
summary
]
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command displays the Quality of Service (QoS) parameters that make up each of the service flows
that are defined on the router for the upstream and downstream. The information shown corresponds to
the QoS parameters that are listed in Appendix C of the DOCSIS 1.1 specification.
Examples
The following example shows typical output for the default form of the
show controllers cable-modem
service-flows
command.
Router#
show controllers cable-modem 0 service-flows
Upstream Flow Scheduler Parameters
Flow Type: Primary
Flow Reference: 1
Service Flow ID: 3
Service ID: 2
QoS Set Type: 7
QoS Traffic Priority: 0
QoS Max Sustained Traffic Rate: 0
QoS Max Traffic Burst: 1522
QoS Min Reserved Traffic Rate: 0
QoS Min Reserved Rate Pkt Size: 0
QoS Timeout For Active Param: 0
Qos Timeout For Admitted Param: 200
Max Concatenated Burst: 0
Scheduling Type: 0x2
Request/Transmission Policy: 0x0
Nominal Polling Interval: 0
Tolerated Poll Jitter: 0
number
Identifies the cable interface (always
0
).
sfid
(Optional) Displays detailed information for a specific service flow, as
identified by its service flow ID (SFID). The valid range for
sfid
is 1 to
2147483647.
summary
(Optional) Displays a summary report of all service flows.
Release
Modification
12.2(15)CZ
This command was introduced for the Cisco uBR905 and Cisco uBR924
cable access routers, and the Cisco CVA122 Cable Voice Adapter.