6-183
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
Debug Commands
Debug Commands
This section describes the following
debug
commands, which are not normally needed to install or
configure the Cisco cable CPE devices. These commands are used to troubleshoot the device’s
installation or configuration.
•
debug cable-modem bpkm
•
debug cable-modem bridge
•
debug cable-modem error
•
debug cable-modem interrupts
•
debug cable-modem mac log
•
debug cable-modem mac messages
•
debug cable-modem mac messages dynsrv
•
debug cable-modem map
•
debug cable-modem up-dis
•
debug crypto ipsec client ezvpn
•
debug docsis ssd
•
debug usb
Additional
debug
commands are documented in the
Cisco IOS Debug Command Reference
, available on
Cisco.com and the Documentation CD-ROM.
Caution
The
debug
commands are primarily intended for use in controlled test and troubleshooting situations
with a limited volume of traffic. You should use caution when enabling debug messages because sending
these messages to the console consumes system resources. Turning on too many types of debug messages
can adversely affect the router’s network performance, depending on what messages are being displayed
and the type of traffic that is occurring.