A-30
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Appendix A Using the ROM Monitor
history
history
To display the last 16 commands given at the ROM monitor prompt, use the
history
command in ROM
monitor mode.
history
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values.
Command Modes
ROM monitor
Command History
Usage Guidelines
The ROM monitor keeps a record of the last commands given at the ROM monitor prompt (up to 16),
similar to the way this is done with the Korn shell. Use the
history
command to display these commands,
and the
repeat
command to repeat them one or more times.
Tip
When you use an
alias
, the
history
list includes the alias and not the actual commands that were
executed.
Note
The
repeat
command is not added to the history list.
Examples
The following example shows how to reset the ROM monitor and return it to a known state:
rommon 9 >
history
1 boot sysfiles/ubr10k-k8p6-mz.12211BC3
2 dev
3 dir disk0:
4 confreg
5 confreg 0x00
6 cont
7 break -c
8 break
Release
Modification
11.3 NA
This command was introduced on Cisco uBR7200 series routers.
12.1(5)EC
Support was added for Cisco uBR7100 series routers.
12.2(4)BC1
Support was added for the Cisco uBR10012 router. Changes were also made
to the boot procedure after breaking into ROMMON to ensure that all
hardware and software registers are in a known state before loading the new
image.