2-263
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd factory-default
cable telco-return spd dhcp-
authenticate
Indicates that telco-return CMs must use a specific Dynamic Host
Configuration Protocol (DHCP) server.
cable telco-return spd dhcp-
server
Identifies the IP address of the DHCP server that the telco-return CMs
must use.
cable telco-return spd dial-
timer
Sets the number of seconds that a telephone connection is idle before
the telco-return CM disconnects the call.
cable telco-return spd
manual-dial
Enables the telco-return CM to operate in manual-dial mode.
cable telco-return spd
password
Sets the password that the telco-return CM uses for authentication
when establishing a PPP connection.
cable telco-return spd
phonenum
Sets the telephone numbers that the telco-return CM dials when
connecting to the headend’s network access server.
cable telco-return spd ppp-
authenticate
Selects the authentication procedure to use when the telco-return CM
is establishing a PPP connection.
cable telco-return spd
radius-realm
Selects a RADIUS server domain to use for the login response string.
cable telco-return spd
service-provider
Includes the service provider name in the SPD.
cable telco-return spd
threshold
Sets the number of failed dial-up connections that can occur before the
CM indicates a connection failure.
cable telco-return spd
username
Sets the username that the telco-return CM uses for authentication
when establishing a PPP connection.
