2-271
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd ppp-authenticate
Related Commands
Command Description
cable telco-return enable
Enables telco-return functionality.
cable telco-return interval
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
cable telco-return
registration-ip
Selects a different IP address for the telco-return CM to send its
registration requests.
cable telco-return spd dhcp-
authenticate
Indicates that telco-return CMs must use a specific DHCP server.
cable telco-return spd dhcp-
server
Identifies the IP address of the DHCP server that the telco-return
CMs must use.
cable telco-return spd dial-
timer
Sets the number of seconds that a telephone connection is idle before
the telco-return CM disconnects the call.
cable telco-return spd
factory-default
Indicates the SPD that the telco-return CM uses during the
initialization process.
cable telco-return spd
manual-dial
Enables the telco-return CM to operate in manual-dial mode.
cable telco-return spd
password
Sets the password that the telco-return CM uses for authentication
when establishing a PPP connection.
cable telco-return spd
phonenum
Sets the telephone numbers that the telco-return CM dials when
connecting to the headend’s network access server.
cable telco-return spd
radius-realm
Selects a RADIUS server domain to use for the login response string.
cable telco-return spd
service-provider
Includes the service provider name in the SPD.
cable telco-return spd
threshold
Sets the number of failed dial-up connections that can occur before
the CM indicates a connection failure.
cable telco-return spd
username
Sets the username that the telco-return CM uses for authentication
when establishing a PPP connection.
